12-27-2024 08:23 AM
I currently have one of the APs at my home running using a POE injector. The switch keeps failing to provide power. Always problems with the network. I have done all possible to make this work. APs are upgraded to the latest upgrade so is the switch. (ICX715-c12) I had a previous forum going on here Solved: RUCKUS Forums - Re: Switch icx 7150-c12p is not powering POE, runn... - Page 5 - CommScope R.... Issue is still going on. I think the switch is done for. Too many problems, have to constantly restart.
12-27-2024 02:22 PM
second AP is only blinking red now. When this happens, I have to restart the switch a couple more times for it to connect the right way and or get the right amount of power. I changed the heads of the cables for new ones just in case there was bad connection. Yes I have RJ45 heads and yes I have a crimper. I am certified, network engineer.
12-30-2024 05:51 AM
Hi @ramirezcrisaf
Greetings!
Thank you for your prompt response and for providing the detailed information.
The issue you are experiencing may be related to an older version of the firmware running on your RUCKUS ICX-7150-C12P switch. To check the same and assist further, please share the outputs of the following commands:
enable
show version
show flash
If you have any questions or require further clarification, please do not hesitate to reach out.
Thank you again for your patience and understanding.
Best regards,
Imran Sanadi
RUCKUS Lennar Home Community
12-30-2024 07:45 AM
Sir, with all due respect. I have tried 3 different versions of firmware. If you go back to my previous ticket you will see I was told to do the updates already.
12-30-2024 07:53 AM
Hi @ramirezcrisaf
Thank you for the response.
To check the details, please share the requested command outputs.
Thank you again.
Best regards,
Imran Sanadi
RUCKUS Lennar Home Community.
12-30-2024 08:47 AM
telnet@ICX7150-C12 Router#sh flash
Stack unit 1:
NAND Type: Micron NAND 2GiB (x 1)
Compressed Pri Code size = 33554432, Version:08.0.95nT213 (SPR08095n.bin)
telnet@ICX7150-C12 Router#sh ver
Copyright (c) Ruckus Networks, Inc. All rights reserved.
UNIT 1: compiled on Jan 21 2024 at 08:29:16 labeled as SPR08095n
(33554432 bytes) from Primary SPR08095n.bin (UFI)
SW: Version 08.0.95nT213
Compressed Primary Boot Code size = 786944, Version:10.1.26T225 (mnz10126)