Interne lt stopped working through icx7150-c12p

[Pantheratl44]

Internet router works fine and r510 units are all able to power up. I unplugged and plugged in the device a few times but devices won’t reconnect. 510 is solid green on control unit but flashing green on power

[ssolipuram99]

[Imran_ruckus]

Hi @ssolipuram99 
Greetings!!!

Thank you for contacting the RUCKUS Community forums.

As this case was raised by @Pantheratl44 

Please raise a new post with the above description on RUCKUS Lennar Support

Thank you again for your understanding.

Best regards,
Imran Sanadi
RUCKUS | Lennar Home Community Support

[Pantheratl44]

I re-did some of the configurations as outlined but still did not see a change with getting the system back online. 

[Pantheratl44]

I also wanted to add the port lights are on green when the ethernet line plugged in. 

[Imran_ruckus]

Hi @Pantheratl44 

Greetings!!!

Thank you for your recent correspondence and update.

We may need to check some configurations of your RUCKUS ICX-7150-C12P Switch to troubleshoot this issue.

To proceed with troubleshooting the issue, please follow the steps outlined below to access the Command Line Interface (CLI) and provide the necessary command outputs:

1. First, identify the current IP address assigned to the switch ICX-7150-C12P by your local router. You can use an IP scanner tool to easily locate the switch's IP address on your network. Here is a guide on how to perform this using IP Scanner free applications: 

https://community.ruckuswireless.com/t5/RUCKUS-Lennar-Support-Knowledge/How-to-find-the-IP-Address-o...

2. Once you have identified the IP address of the switch, proceed to access the Command Line Interface (CLI) of the RUCKUS ICX-7150-C12P switch. Here is a guide on how to access the CLI: 

https://community.ruckuswireless.com/t5/RUCKUS-Lennar-Support-Knowledge/How-to-access-the-Command-Li...

If you can access the Command line the prompt should look like below:

ICX7150-C12 Router> OR

ICX7150-C12 Switch>

3. After successfully accessing the CLI, please execute the following commands and provide the outputs:

         enable

   show version

   show flash

   show inline power

   show inline power detail

   show interface brief

Please share the command outputs or screenshots if you encounter any issues or errors during these steps. 

Feel free to reach out if you have any questions or require further assistance.

Thank you for your cooperation and patience.

Best regards,
Imran Sanadi
RUCKUS | Lennar Home Community Support