Icx issue after power out and firmware upgrade

[Wecovernc]

I have an icX router in my Lennar home. Every time the power goes out we have a connectivity issues. I also did a firmware upgrade but still have issues and you can see that. I also have we’re says the switch is disconnected.failed to ping 

 

 

 

[Wecovernc]

ICX7150-C12 Router>enable

No password has been assigned yet...

ICX7150-C12 Router#show version

  Copyright (c) Ruckus Networks, Inc. All rights reserved.

    UNIT 1: compiled on Sep 23 2019 at 00:00:25 labeled as SPR08090d

      (32539748 bytes) from Secondary SPR08090d.bin (UFI)

        SW: Version 08.0.90dT213

      Compressed Secondary Boot Code size = 786944, Version:10.1.15T225 (mnz10115)

       Compiled on Thu Jan 31 07:08:55 2019

  HW: Stackable ICX7150-C12-POE

==========================================================================

UNIT 1: SL 1: ICX7150-C12-2X1G POE 12-port Management Module

      Serial  #:FEK3841R0ZW

      Software Package: ICX7150_BASE_L3_SOFT_PACKAGE

      Current License: 2X1G

      P-ASIC  0: type B160, rev 11  Chip BCM56160_B0

==========================================================================

UNIT 1: SL 2: ICX7150-2X1GC 2-port 2G Module

==========================================================================

UNIT 1: SL 3: ICX7150-2X10GF 2-port 20G Module

==========================================================================

 1000 MHz ARM processor ARMv7 88 MHz bus

 8192 KB boot flash memory

 2048 MB code flash memory

 1024 MB DRAM

--More--, next page: Space, next line: Return key, quit: Control-c

ICX7150-C12 Router#show flash

Stack unit 1:

  NAND Type: Micron NAND 2GiB (x 1)

  Compressed Pri Code size = 28660224, Version:08.0.90dT211 (SPS08090d.bin)

  Compressed Sec Code size = 32539748, Version:08.0.90dT213 (SPR08090d.bin)

  Compressed Pri Boot Code size = 786944, Version:10.1.15T225 (mnz10115)

  Compressed Sec Boot Code size = 786944, Version:10.1.15T225 (mnz10115)

  Code Flash Free Space = 1131028480

ICX7150-C12 Router#

[Imran_ruckus · Accepted solution]

Hi @Wecovernc 

Greetings!!!

Thank you for the response and the information you shared. 

This issue is because your switch is running on the Routing code (SPR). The Switch should run on the Switching code (SPS) to avoid these issues for Lennar home users. Due to a power outage/power spike, the Switch boots up on the other partition which may be running on a ‘Routing Code’ results in causing this issue.

As I can see from the output you shared, your Switch is booted up on the secondary partition which is running on Routing code (SPR) as highlighted in the below screenshot. 

Please Enter the below commands in CLI to fix this issue:

Note: Hit Enter to accept each command 

enable

copy flash flash secondary 

boot system flash secondary yes 

Please let me know if you have any queries in this regard.

NOTE: Please feel free to mark this post as ACCEPTED SOLUTIONS, if your issues is resolved.

Thank you again for your patience and understanding.

Best regards,

Imran Sanadi

RUCKUS Lennar Home Community.