ICX7150-C12 fails in POE after image was updated to SPS08095g

[ethan]

The image of ICX7150-C12 was updated to 08095g from 08090d since the internet connection dropped frequently (ICX7150-C12-Router mode issue). 
So, the primary and secondary codes were all updated to SPS08095g. 

After this image update, R510 APs are not powered-up.
I found that the POE was not enabled by default and enabled all ports from GUI as shown below. Even after this, APs are not powered up. 

Are there additional configuration required?

[ethan]

Pull bak the imgae version to SPS08090d (using SPS08090dufi.bin) enabled POE properly and all APs became operational. 

I see non-zero version numbers as shown below: 

Why SPS08095gufi.bin does not configure POE?

[mark_pledl]

If you do such a big step upgrading the switch it can be that it will upgrade also the POE firmware. 

If I remeber right, you will see this on cli giving you the status of the POE upgrade in 10% steps. No AP will boot before that upgrade is finished and teh process starts when the switch has booted up after firmware upgrade.

It can take up to 30 minutes till it is finished.

Br,

Mark.