Make sure the cable is actually connected to the ICX-7150-C12P ( Switch ) In one of the 12 ports in the middle
Make sure the cable is in good condition so that both ends and connectors look good.
Note : you will see a light come on when a device is connected via Ethernet on 1 of the 12 ports available.
Here I will leave a short guide how to connect the devices properly :
Most common Setups for Lennar homes users
Please check SYST and power the lights' status of the ICX7150 Switch, describe those lights for us first.
Also let me add more detail to understand the LED lights of your Access points.
R510 LED lights
To solve the issue, you need to get access via console, using two connections one is for console access using the USB to type C cable (the USB will be connected on your computer and the type C on your ICX7150 Switch) now the second connection will be an Ethernet cable from your computer to the out-of-band port on your ICX 7150 Switch) don't worry the next guide explains the port locations and there are pictures about it, however I will advise performing a hard factory reset first, let me add the steps.
- Remove power from the switch.
- Press and hold the Reset button while applying power to the switch.
- After all the system LEDs flash amber, release the Reset button.
When all the system LEDs blink green, all the configuration data are erased and the switch is returned to its factory configuration. When all the system LEDs are solid green, the erase process is complete and the system reloads. Once reloaded and the SYST LED is steady green, the factory reset is complete.
Ruckus ICX 7150/7650 -ERASE SYSTEM TO FACTORY DEFAULT WITH RESET BUTTON(Tutorial video)
2:If the Switch is not responding to the factory reset, you need to perform the software recovery process,
Please read the guide carefully before start the steps.
How to perform a Software recovery on an ICX7150 switch
Ruckus ICX Recovery tutorial video
Lennar Home Community