cancel
Showing results for 
Search instead for 
Did you mean: 

ICX 7150 Not sending power through POE

akalala
New Contributor

We lost power both APs aren’t receiving power after power returned. I have Reset all items several times APs and switch. I have switched cables where possible. I have attempted reboot using coms port that didn’t accept a boot load, flash attempted but failed. Boot said invalid. Not sure what I could do here. 

46 REPLIES 46

Also the 2nd of the 2 AP says that it is disconnected

Hi @akalala 

Greetings!!!

Thank you for the response and the information you shared.

Could you please let me know if you have Upgraded your Switch to the latest recommended version as mentioned in my previous post?

Please confirm and let me know if you have any queries in this regard.

Thank you again for your patience and understanding.

 

Best regards,

Imran Sanadi

RUCKUS Lennar Home Community.

Yes I believe I was able to updated yesterday

Hi @akalala 

Thank you for the response and the update.

Could you please share the output of the below commands from CLI?

enable 

show flash

show version

show inline power 
show interface brief

Please let me know if you have any queries in this regard.

Thank you again for your patience and understanding.

 

Best regards,

Imran Sanadi

RUCKUS Lennar Home Community.

Pics to follow