11-09-2022 12:13 PM
Hello,
We recently purchased the home and do not have access to the Ruckus system. Passwords given by previous owners do not work. When I try a factory reset the lights flash several times the system reboots but the previous owners names still pop up as the SSDI. The steps that I as well as an AT&T tech have take are to up plug the switch, wait sever minutes (in one case I waited several days) and plug in the switch while simultaneously holding the reset button for about 30 seconds. And same result. Is there anything else that I can try? Perhaps connect via hardwire? Thanks!
Solved! Go to Solution.
11-09-2022 12:26 PM - edited 11-09-2022 12:39 PM
Hi @BrennanS
Hope you are doing well !
Basically you do not need to reset the ICX-7150-C12P because that device only provides power to the Wireless Access Points.
Here is how to connect correctly the devices
Most common Setups for Lennar homes users
The access point is the devices that provides wireless connectivity :
ICX-7150-C12p provides power to the wireless access points and wired connectivity
If you want to reset the Wireless Name from and pre-configured SSID ( Wireless signal ) properly you need to preform a factory reset to the Access Point .
Physical Factory Reset an Access Points Ruckus
Best Regards
Fernando Vasquez
11-09-2022 12:26 PM - edited 11-09-2022 12:39 PM
Hi @BrennanS
Hope you are doing well !
Basically you do not need to reset the ICX-7150-C12P because that device only provides power to the Wireless Access Points.
Here is how to connect correctly the devices
Most common Setups for Lennar homes users
The access point is the devices that provides wireless connectivity :
ICX-7150-C12p provides power to the wireless access points and wired connectivity
If you want to reset the Wireless Name from and pre-configured SSID ( Wireless signal ) properly you need to preform a factory reset to the Access Point .
Physical Factory Reset an Access Points Ruckus
Best Regards
Fernando Vasquez
11-09-2022 01:07 PM
Thanks so much. So I only need to reset one of my two APs if I understand you correct and I'll be able to configure through the app?
11-09-2022 01:09 PM - edited 11-09-2022 01:15 PM
Hi @BrennanS
You are totally correct ! Once you finished configuring the AP you can connect back the other Access Point to the switch
Ruckus Unleashed Set-up using your Mobile
Ruckus Unleashed Set-up using your Mobile
Most common Setups for Lennar homes users
Best Regards
Fernando Vasquez
11-09-2022 01:15 PM
Thank you so much. Take Care!!