03-12-2025 06:29 AM
Hi, our access point's (AP) has been experiencing frequent power off's. Every time my ICX 7150 C12 switch need manually power off and power back on after AP's power on. I reset my both AP and getting same issue. Please help to resolve issue.Before power cycle with no active AP's
After power recycle with active AP's
03-12-2025 07:43 AM
Hello @ariark ,
Greetings!
Thank you for contacting RUCKUS Lennar Home Community.
I hope you are doing well!!!
Thank you for the information you shared.
From the case description, I understand that Access points getting turned off and needs power cycle of the Switch.
Before we can help, we need to check few configurations on the Switch and which version the Switch is currently running.
Please follow the below steps and help us with the queries,
1) To check this, we must identify the ‘current’ IP address assigned by your local router to the switch ICX-7150-C12P
I will leave you a guide on how to perform an IP scanner on your local network to identify the switch IP address very easily.
How to find the IP Address of the RUCKUS Devices (Switch and APs) using IP Scanner free applications:
2. Once we identify the IP address of the switch proceed to access remotely to the device “Command Line”
If you can access the Command line should look like this:
ICX7150-C12 Router> OR
ICX7150-C12 Switch>
Please enter the below commands once you log in to CLI and share the output.
Note: Hit Enter to accept each command
enable
show version
show flash
Please share the output of the above commands or share the screenshots if stuck at any step or error (if any) and let me know if you have any queries in this regard.
Thank you again. We appreciate your patience and understanding.
Best regards,
Pinky Rajendran
RUCKUS Lennar Home Community.
03-12-2025 10:46 AM
Hi ,
I could not find my switch ICX-7150-C12P IP address in IP Scanner. I am able to see my AP's IP.
Are any other options available?
Thank you.
03-12-2025 10:54 AM
Hello @ariark ,
Thank you for the response.
I understand that you are unable to find your Switch IP address
We would request you to access CLI through console cable.
Please follow the below RUCKUS Lennar Knowledge base self-help article which will help you to console in the ICX-7150-12CP 'Ruckus Switch
Once you have access to CLI using the console cable, please follow the previous post and share the output or screenshots if you are getting stuck at any point.
Thank you again for your patience.
Regards,
Pinky Rajendran
RUCKUS Lennar Home Community
03-12-2025 12:32 PM
Software Version
I have attached the switch version of Switch. Please let me know if you have any questions.
Thank you.