02-05-2023 09:16 AM
Had a power surge and Ap went down. Did a power cycle and a factory reset and that did not do anything. Even tried to console in and recover software, but could not get that to work. Just need to RMA the device and get a new one set up. Any recommendations on fixing the issue if a power surge happens?
02-06-2023 03:43 PM
Attached should be the photos
02-06-2023 03:43 PM
One more attached photo.
02-06-2023 03:45 PM
now the photos attached.
02-06-2023 05:07 PM
Attached is the pictures.
02-07-2023 04:54 AM
Hi @MikeyH
Basically if the switch has one green and one yellow light, it means that the switch is stuck in boot mode.
1-Please try to disconnect from the Power outlet the ICX- 7150 and reconnect it.
2-Please try to press the reset button using a paper click or a small stick
Video link:https://www.youtube.com/watch?v=6jHMTdo_hK4
If this step doesn't work, we need to perform a software recovery.
Here is the quick guide to perform software recovery.
How to perform a Software recovery on an ICX7150 switch
Ruckus ICX Recovery Load boot code from boot monitor
https://www.youtube.com/watch?v=RHriOYYD_iI&t=7s
Note: after fixing the issue of the Switch been stuck in boot mode, please perform an upgrade to the code 08095g UFI and upgrade both partitions with the switching code file named SPS08095gufi.bin, so perform the software recovery using the code 08090k with the upgrade image file named SPS08090k.bin, then when the switch is back to normal upgrade to the file SPS08095gufi.bin for both partitions primary and secondary.
1.Upgrade a Switch ICX-7150-C12P using a USB flash drive
Best regards,
Jayavidhya
Lennar Home Community