I have an ICX7150-C12P that isn’t booting properly. When I connect to it via the serial console, I get errors like:"ZQ calibration error (P offset) - Manual IO programming required for correct operation""Validate Shmoo parameters stored in flash .......
Hello, I have ICX7450-48 switch that does not seem to forward packets correctly. I'm new to this hardware and not sure if this is a misconfiguration on my side or a hardware fault.The switch is running the following firmware version and was reset to ...
i need to check if i can use Cisco SFP with Ruckus Switch ICX7150-48PF?
Hi All,I am attempting to create a DHCP server on the ICX 7850 switch to provide service for a few VLANs that are also defined on the same switch. I have configured the DHCP Server and pool for VLAN 1030. But, when I connect a client device on a unta...
Commanddevice# configure terminal device(config)# ipv6 multicast flood-unregisteredis not available on either 09.0.10j_cd6 or 10.0.10f_cd1 on the 7150-48zp as suggested in the respective linked RUCKUS FastIron IP Multicast Config GuidesMulticast Disc...
