RUCKUS ICX Switch Family

|

ICX Switches

The RUCKUS ICX® Campus Switch family delivers a complete, scalable, and high-performance routing and switching solution that supports today’s demanding network applications.

Forum Posts

Sorted by:

ASK the Pack

Switch recovery with 09.0.10c

I have a 7150 48p that will not boot.I am in recovery mode the recover instructions say to use the boot code from the firmware download but with 09.0.10c there is no boot code in the download.Any ideas?

ICX-7150-C12 static IP interface disappears from the network after 25 seconds after boot completes

I have an ICX 7150 C12 which has been running fine for over 2 years on 8.0.9. Today I added an SPF+ RJ45 module to on of the uplink ports to see if I could use it to connect with my router, it didn't, of course, so i pulled the module out and reconn...

Resolved! Applying a licence to a switch stack

I'm fairly new to networking so I apologize if this is fairly obvious. I googled, but I was unsuccessful/confused.We recently received new ICX7400 switches. I consoled into each one and upgraded the firmware to 08090k and applied licenses to each. We...

Disabling status-server (Code field 12) on a ruckus icx 7450 switch

I've got a Wired 802.1x implementation with a ruckus switch as the Radius client and a Microsoft NPS acting as the Radius server.The below config line on the switch is the one causing me a lot of grief and I see a constant error showing up on Event V...

Resolved! UPLINK termination to the stack members and roles

We are planning build a new ICX7450 stack with 4 members, and will have two 10G UPLINKs to our core network.These 10G connection will be terminated to module 2 (eth1/2/x) in different unit for physical redundancy.My question here is to which unit we ...

Related Self-Help

Find More Solutions

Top Kudoed Authors

User

Count

2

1

1

1

1