I'm trying to upgrade the software from 08.0.91 to a newer version, however I'm having trouble doing so. I tried the copy command, but no luck. It's almost as if copy tftp isn't working for some strange reason.
I figured the only option was TFTP, as this model doesn't have a USB port. But any ideas on how to proceed with this upgrade? Current output:
SSH@ICX7150-C08P Switch#show ver Copyright (c) Ruckus Networks, Inc. All rights reserved. UNIT 1: compiled on Jun 6 2019 at 20:57:00 labeled as SPS08091 (28774816 bytes) from Primary SPS08091.bin (Non-UFI) SW: Version 08.0.91T211 Compressed Primary Boot Code size = 786944, Version:10.1.16T225 (mnz10116) Compiled on Sat May 25 10:09:26 2019
HW: ICX7150-C08-POE ========================================================================== UNIT 1: SL 1: ICX7150-C08-2X1G POE 8-port Management Module Serial #:FMF3845Q09R Software Package: BASE_SOFT_PACKAGE P-ASIC 0: type B160, rev 11 Chip BCM56160_B0 ========================================================================== UNIT 1: SL 2: ICX7150-2x1GF 2-port 2G Module ========================================================================== 1000 MHz ARM processor ARMv7 88 MHz bus 8192 KB boot flash memory 2048 MB code flash memory 1024 MB DRAM STACKID 1 system uptime is 3 day(s) 35 minute(s) 51 second(s) The system started at 00:16:17 GMT+00 Thu Jan 01 1970
The system : started=factory reset reloaded=by "factory reset"
====================================================================================== =============== WARNING: FI image is not booted from UFI!!! =============== ====== Please download UFI image and reboot the system for full functionality ====== ======================================================================================
copy tftp startup-config
doesn't seem to want to work either. are these commands available in the .92 version?