cancel
Showing results for 
Search instead for 
Did you mean: 

Ruckus ICX7150 C08 TFTP Upgrade

kristphr
New Contributor III

Hello,

I'm trying to upgrade the software from 08.0.91 to a newer version, however I'm having trouble doing so. I tried the copy command, but no luck. It's almost as if copy tftp isn't working for some strange reason. 

I figured the only option was TFTP, as this model doesn't have a USB port. But any ideas on how to proceed with this upgrade? Current output: 

SSH@ICX7150-C08P Switch#show ver
  Copyright (c) Ruckus Networks, Inc. All rights reserved.
    UNIT 1: compiled on Jun  6 2019 at 20:57:00 labeled as SPS08091
      (28774816 bytes) from Primary SPS08091.bin (Non-UFI)
        SW: Version 08.0.91T211
      Compressed Primary Boot Code size = 786944, Version:10.1.16T225 (mnz10116)
       Compiled on Sat May 25 10:09:26 2019

  HW: ICX7150-C08-POE
==========================================================================
UNIT 1: SL 1: ICX7150-C08-2X1G POE 8-port Management Module
      Serial  #:FMF3845Q09R
      Software Package: BASE_SOFT_PACKAGE
      P-ASIC  0: type B160, rev 11  Chip BCM56160_B0
==========================================================================
UNIT 1: SL 2: ICX7150-2x1GF 2-port 2G Module
==========================================================================
 1000 MHz ARM processor ARMv7 88 MHz bus
 8192 KB boot flash memory
 2048 MB code flash memory
 1024 MB DRAM
STACKID 1  system uptime is 3 day(s) 35 minute(s) 51 second(s)
The system started at 00:16:17 GMT+00 Thu Jan 01 1970

The system : started=factory reset   reloaded=by "factory reset"

======================================================================================
===============       WARNING: FI image is not booted from UFI!!!      ===============
======  Please download UFI image and reboot the system for full functionality  ======
======================================================================================

copy tftp startup-config

doesn't seem to want to work either. are these commands available in the .92 version? 

5 REPLIES 5

corey_costello
New Contributor III

What error do you get from the console when you try and tftp?

your post doesn’t say anything about it. 

can you ping your tftp server?

@corey_costello it only states "Incomplete command." when entering the command. 

I can't ping the tftp server (not on the same network yet). 

@kristphr you have to put in the whole command. 

Do a “copy tftp ?” and you’ll see the options. 

it has to be on a network that can reach your tftp server. 

sam_evans
New Contributor III

You can also reference the upgrade guide for the complete commands required and options available for upgrading.

For example here is the 08.0.91 upgrade guide: https://support.ruckuswireless.com/documents/2878-fastiron-08-0-91-ga-software-upgrade-guide