08-09-2024 06:59 PM
Hello,
I just picked up a used ICX 7150-48P on ebay to replace a toy Ubiquiti fanless poe switch.
The seller had shipped the switch without the rack ears attached.
The only issue is that the supplied screws were too big. The screws was that came with the ears in a baggie taped to the switch wouldn't engage the threads on the switch cabinet.
Thinking this was the wrong size, I ended up getting a bag of 50 8-32 x 5/16 from Amazon.
They were the same size, same coarse threading. Still doesn't fit.
I was hoping for a mechanical drawing or other document showing screw size but no joy.
Thanks in advance,
John
Solved! Go to Solution.
08-14-2024 01:32 PM
Thanks for the link, but I had already viewed it previously. I will be unkind and say that document was absolutely useless, as it mentioned a couple of rack kits that used 8-32 screws, which are too big for the threads on the side of the ICX 7150-48P.
On a lark, I went and ordered the next size down from Amazon:
#6-32x5/16" flat head screws. Guess what, these worked.
08-12-2024 07:46 AM
Hi @u35828
Greetings!!!
Thank you for contacting the RUCKUS Community forums.
Could you please let me know if this is a Lennar Home RUCKUS setup?
Please confirm.
Thank you again.
Best regards,
Imran Sanadi
RUCKUS Lennar Home Community.
08-12-2024 11:59 AM
No, it is not. As per my original post, the ICX-48P replaced a Ubiquiti USW-24P.
08-13-2024 05:30 AM
Hello @u35828
I hope this message finds you well.
Thank you for confirming. I am now forwarding this case to the ICX Switching team for further assistance.
We appreciate your patience and understanding.
Best regards,
Imran Sanadi
RUCKUS Lennar Home Community
08-13-2024 11:15 AM
Hi u25828
Thank you for reaching us
Please refer the below mentioned Hardware reference guide for more details about the switch installation
You can also refer the "mounting the device" section from the above link for more details about installing the unit.
I hope the above details help
Thanks