cancel
Showing results for 
Search instead for 
Did you mean: 

Multi-VLAN Access Port for voip/data

secron
New Contributor II

Hi All, 

Need assistance in configuring data and voice vlan on a port.  

vlan 101 - voice

vlan 102 - data 

How can I configure Multi-VLAN Access Port?  I'd like the phone to be on the voip vlan but assign data vlan when a pc is connected to the phone data port.  

 

 

2 REPLIES 2

Chandini
RUCKUS Team Member

Hi Secron 

Thank you for reaching us . 

From the details shared I suppose you are looking for a daisy chain setup in regards to the end device. 

Consider interface 1/1/1 which is connected to VOIP and PC then you can use the below configuration to achieve your requirement. 

 

Device#con t
Device(config)#vlan 101
Device(config-vlan-101)#tagged e 1/1/1 // this would be for a VOIP phone
Added tagged port(s) ethe 1/1/1 to port-vlan 101.
Device(config-vlan-101)#vlan 102
Device(config-vlan-102)#untagged e 1/1/1 // this would be for a PC device
Added untagged port(s) ethe 1/1/1 to port-vlan 102.

you can also refer below guide for more details 

L2 switching configuration Guide:

I hope this helps

Thanks 

 

 

jdryan
Moderator
Moderator

Hi Secron, 

Adding to the details shared above : 
Device#con t
Device(config)#vlan 101
Device(config-vlan-101)#tagged e 1/1/1 // this would be for a VOIP phone
Added tagged port(s) ethe 1/1/1 to port-vlan 101.
Device(config-vlan-101)#vlan 102
Device(config-vlan-102)#untagged e 1/1/1 // this would be for a PC device
Added untagged port(s) ethe 1/1/1 to port-vlan 102.

Post that, on the interface : 

Device(config)#int eth < port number > 
Device(config-if-e1000-<port number>)# voice-vlan 101

Should help as well. 

 

Let us know if the same helps ! 

 

Regards