ICX7450-24P Rebooting

[michaels2408]

Good morning,

I have an ICX7450-24P that I purchased used. When I first fired this unit up and began my configuration it seemed fine. It came with 8.0.30 firmware in switch mode. I immediately upgraded to 8.0.95n, then after seeing all ok, Updated to 09.0.10j_cd2 . Updated in both primary and secondary.

Copyright (c) Ruckus Networks, Inc. All rights reserved.
    UNIT 1: compiled on Apr 25 2024 at 05:08:28 labeled as SPR09010j_cd2
      (33554432 bytes) from Primary SPR09010j_cd2.bin (UFI)
        SW: Version 09.0.10j_cd2T213
      Compressed Primary Boot Code size = 786944, Version:10.1.26T215 (spz10126)
       Compiled on Tue Nov 29 07:43:15 2022

 After I began configuration the unit randomly started rebooting approx every 14-15 minutes, like clock work. Tried going back to 08.0.95n, tried resetting to factory defaults via linux command line

factory set-default

But the reboot issue remains. I have tried with and without POE. I have started removing the 3 4x10g modules to see if one of those are bad. Also plan on trying disabling the fans one a time to see if either are the culprit. I am only using 1 PS of the two. Since reading through the forums I keep seeing this issue popping up when using router code on a device in the Lennar threads. So that leads to question what is Lennar? Is it hardware specific in the ICX switch that makes them incompatible with router code? Or is it a separate component of networking? Is there anything I can do to verify or drill down to find the problem? I have also checked

show reload

 to verify there is no reload after x minutes set. Its clean. The log only shows from the last reload so nothing there.

Any help would be greatly appreciated.

Mike