ICX7150 PoE power supply and cable inspection

[CHOIYOUNGJAE]

Hello.

I'm contacting you because I have a question.

■ Equipment in use
-ICX7150
Version: SPS08090d

AP: R310

There seems to be a problem with the cable and the power supply to the AP is not working properly.

If you look at the log, the assigned values are the same, but the values in use are different.

What are the other reasons? If it's normal, isn't it normal that all APs have the same amount of power?

I set the automatic cell size, so is the value different?

What is the normal power (mW) value for the R310 AP?

※ Is there a command that can check the port error counter like CISCO?

Help me.
Thank you.

[kamlesh_murthyr]

Hi @CHOIYOUNGJAE 

I do understand that you are facing power issue with the AP.

May I know the port no where the AP is connected ?

As well to check the crc errors on port you use following below commands :

Show interface Ethernet x/x/x

Show statistics Ethernet x/x/x 

You can refer APR310 data sheet for its minimum required power to get power On in below link : https://webresources.ruckuswireless.com/datasheets/r310/ds-ruckus-r310.pdf

POWER3
Power Supply Maximum Power Consump੏on
802.3af · 11W
DC input 12 VDC 10A · 9W

Regards,

Kamlesh M

[CHOIYOUNGJAE]

Hello, Kamlesh Murthyr

Provide port name information.

Please help me
Thank you.

[CHOIYOUNGJAE]

Hello, Kamlesh Murthyr

Provide port name information.

Please help me
Thank you.

[kamlesh_murthyr]

Hi @CHOIYOUNGJAE ,

I do see that you have ran "show interface brief"

Please do run "show interface ethernet x/x/x" or "show statistics ethernet x/x/x" for CRC errors.

For ex : "show interface ethernet 1/1/5" or "show statistics Ethernet 1/1/5"

Regards

Kamlesh M