10-22-2022 01:46 PM
I moved into a Lennar home a few months ago. I'm trying to setup my network:
ATT Gateway (BGW210-700) -> OpenWrt router -> ICX 7150-C12P -> 2 R510 APs with:
- Gateway -> OpenWrt router: IP Passthrough
- OpenWrt router -> ICX 7150-C12P: ethernet from a LAN port on the router to port #1 on the ICX 7150-C12P.
- ICX 7150-C12P -> 2 R510 APs: POE
Is the above setup seems reasonable?
While Internet is available via the 2 APs, the switch is showing as disconnected on the Unleashed admin dashboard with the following message:
10-25-2022 12:05 PM - edited 10-27-2022 12:03 PM
10-26-2022 11:38 AM
Unfortunately I don't know the IP of the switch. I set that IP 192.168.1.127 hoping that it's up but it doesn't seem to work.
I guess the only option now is serial?
10-27-2022 12:09 PM
Hope you are doing well
Idk why my replied was done like multiples times.
-You can check on your router that there is a tab which is most often called 'client devices' to check the IP addresses that the router has been leased to.
-You can downloads an IP scanner : https://www.advanced-ip-scanner.com/
-As you mentioned you can access to the switch via console
-Some times a hard reboot is needed to start seeing the IP address of the switch
10-25-2022 11:55 AM - edited 10-27-2022 12:02 PM
10-26-2022 09:40 AM - edited 03-19-2023 07:45 AM
Below is the link to reset password on ICX switch.
Adding to the post a link from RUCKUS Lennar Support where Imran was helping customer with accessing the switch . He has shared lot of links which will help in troubleshooting the device better.
I hope this helps. Thanks