i have ZoneDirector 1100 and now have ZoneDirector 3000 but i can't alow AP
from ZoneDirector 1100 to ZoneDirector 3000?
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-08-2016 10:55 AM
4 REPLIES 4
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-08-2016 11:05 AM
Hello Salah,
Please mention the firmware version of ZD 1100 and ZD 3000 running.
Are you trying to migrate all the APs from ZD 1100 to ZD3000 or only few APs like load balancing between ZD 1100 and ZD 3000?
Regards,
Ahamed.
Please mention the firmware version of ZD 1100 and ZD 3000 running.
Are you trying to migrate all the APs from ZD 1100 to ZD3000 or only few APs like load balancing between ZD 1100 and ZD 3000?
Regards,
Ahamed.
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-08-2016 11:29 AM
hi Ahamed
yea all APs, both ZoneDirector is running but ZoneDirector 3000 can't see APs in ZoneDirector 1100
yea all APs, both ZoneDirector is running but ZoneDirector 3000 can't see APs in ZoneDirector 1100
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-08-2016 11:48 AM
Hi Salah,
Please let us know the firmware version running on both the controllers and what are the model number of the APs which are showing connected in the ZD1100?
Regards,
Ahamed.
Please let us know the firmware version running on both the controllers and what are the model number of the APs which are showing connected in the ZD1100?
Regards,
Ahamed.
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-08-2016 03:04 PM
There are a couple of you things you need to do:
1. Make sure both ZD's have the same firmware to limit downtime.
2. Set up your Access Point Policies as below on both ZD's:
Once you have done this all AP's should migrate to the primary ZD.
You then just need to remove the Secondary ZD IP Address and your done.
Good Luck
1. Make sure both ZD's have the same firmware to limit downtime.
2. Set up your Access Point Policies as below on both ZD's:
Once you have done this all AP's should migrate to the primary ZD.
You then just need to remove the Secondary ZD IP Address and your done.
Good Luck