RUCKUS Community Forums are now in READ-ONLY mode while we migrate to a new platform.
You will still be able to read posts and knowledge articles, but will be unable to post new content until Go Live on the new platform Monday August 17.
Lennar Smart Home customers: please contact [email protected] for assistance during the week of August 9-17.
New setup with 3 APs so far connected to the controller - initial setup I had a guest access portal working but was requested to turn on "Bypass CNA" because they've had issues with Apple devices in the past.Turning this option on caused my Galaxy S8...
Was on another thread which said Worldwide codes don't work with US APs. Assumed my ZD will work with US APs as bought in US. Is it a problem that it's a UN00 region code?
Hey guys, I just inherited an R710 AP with Unleashed firmware for home use as a standalone AP. Right now, I'm using an Asus router with Tomato firmware that is broadcasting two SSIDs, each on a separate VLAN (IDs 2 & 100 ,respectively). I would like ...
I have a "new to me" R510 access point that I can't seem to get into.I've done the hold the reset button for over 6 seconds procedure several times now.If the unit is on my lan via a port on my PoE switch, it gets an IP from my DHCP server, and also ...
We all know below Access Points – EOL: H500 R300 R500 R700 T300 T301-S T600 Are these equipments still covered by limited hardware warranty, if yes when will be the last date?
