What is the password for configure.me ssid after factory reset on R510?

[kai_cheung]

I have an R510 that was originally Unleashed, then flashed to run on my Cloud WiFi network and have now removed the unit from the network.  I'd like to flash this back to Unleashed and have done a factory reset by holding the reset button for 10 seconds.  I now see the configure.meXXXXX SSID but it's asking for a network password to connect to that SSID.  Is there a default password?  I thought that there wouldn't be a password requirement at all.

[sanjay_kumar]

Hi @MattT 
Glad to hear that the AP is able connect and you can manage them.
But the SSH access should be allowed by default.
Are you not able to initiate the SSH session or SSH is initiating but unable to login to the CLI?

[MattT]

Hello,

When trying to SSH I get "Network error: connection refused". 

[sanjay_kumar]

Hi @MattT 
It looks to be a network side issue. Because by default the AP has SSH enabled.

[donell2525]

what to do if Configure.me is asking for a password?

[Imran_ruckus]

Hi @donell2525 
Greetings!!!

Thank you for contacting the RUCKUS Community forums.

As this case was raised by @kai_cheung which is old and now closed.

Could you please let me know if this is a Lennar Home RUCKUS setup? If yes, Please raise a new post with the above description on RUCKUS Lennar Support

If not a Lennar home setup, please raise a post under RUCKUS Technologies section for a particular product. 

Thank you again for your understanding.

Best regards,

Imran Sanadi

RUCKUS Lennar Home Community.