How to Remove 7055 Access Point from Wall Mount Bracket?

[mike_schumann]

I have a number of 7055 Access Points wall mounted in some condos.  I can't figure out how to remove these units from their wall plates.  It does not appear that there are any Torx Bracket Screws installed.

Any suggestions would be appreciated, so I don't have to destroy my walls to remove these units.

Thanks,

[dan_kern]

See if this helps

https://www.manualslib.com/manual/963308/Ruckus-Wireless-Zoneflex.html?page=99#manual

[syamantakomer]

Hi Mike,

Refer below two documents and see if that helps.

ZF7055 Adjacent Wall Plate Bracket Installation Instructions

ZoneFlex ZF7055 Quick Setup Guide

[mike_schumann]

@syamantak_omer These documents show how to install the units, but not how to remove them from the wall plate.  From some of the manuals I read, it indicates that the AP snaps into place and then you can secure it with the Torx screws.  I don't think that there are any Torx screws installed on my units.  My problem is that I can't figure out how to unsnap the unit to get it off of the wall plate.

[syamantakomer]

Hi Mike,

I hope someone from forum who has hands-on experience can help you here.