Enable mesh on t300?

[thbert]

I have a legacy Zonedirector with mostly 7762s and I recently obtained a t300. It successfully joined ZD and updated firmware but does not seem to have mesh enabled. According to this https://support.ruckuswireless.com/articles/000001673 the t300 should be able to mesh with 7762s. How do you enable mesh functionality on the t300? thanks

[syamantakomer]

Hi Treebert,

Could you confirm firmware version running on ZD?

Please refer below article. Though it refers a newer ZD version (10.X) but options are similar on older ZD versions (9.x) as well.

https://support.ruckuswireless.com/articles/000002193


Regards,
Syamantak Omer

[thbert]

I'm running ZD 9.8.3.0 build 58. The problem is that ZD says Mesh Mode is disabled on the t300 - how to enable it? No options for enabling it appear in the Configure > Access Point page in ZD for the AP as they do with the 7762s. thanks

[syamantakomer]

Could you share a screenshot.

Regards,
Syamantak Omer

[thbert]

From ZD Monitor > Access Points