HI Anvar,
LAG will not be supported by SZ100, there is Feature Request
already to include this feature.
Kindly connect a Ethernet cable to port1 or Port2 of SZ100 to
configure, please refer Quick setup and getting started Guide below.
https://r...
Antenna patterns are available in Knowledge base article attachments, see below.
https://support.ruckuswireless.com/articles/000002093
If AP models you are looking for are not available in the
attachment, please reach out to us.
Note: Ruckus Zo...
Similar issue reported in 5.2 with reference
to clients getting IP from default valn when Dynamic vlan’s configured. Please
reach out to Ruckus Support for further troubleshooting.
https://support.ruckuswireless.com/contact-us
Regards
Santhosh
Hi Ahmad
Please follow instructions from the link below to recover Zone
Director. If it fails, please reach out to Support for replacement. Kindly note
a hardware Warranty on the unit is necessary to process replacement.
https://support.ruckuswirel...
