CommScope RUCKUS Community Forums

Hi!I need VLAN interface (VE) on ICX7150 (router) always be in state "UP" when all the ports in the VLAN go into an inactive state.Is there analog of command "no autostate" (Cisco)?

Hi team!I test DHCP Snooping on switches ICX7250 and ICX7150 (hw ver. 8.0.9). DHCP-Server was Cisco switch.I configured DHCP Snooping according to manual:    enable acl-per-port-per-vlan    ip dhcp snooping vlan 100   interface lag 1    dhcp snooping...

Hi team!I test broadcast/multicast/unknown-unicast limits on ICX7250 and ICX7150 (hw ver. 8.0.9).I've configured ports as:    interface ethernet 1/1/1     spanning-tree 802-1w admin-edge-port     broadcast limit 96 kbps     multicast limit 400 kbps  ...

I tested of work roaming depending roam-factor between R510 and R720 (both APs saw each other). APs worked under vSZ (vscg-5.0.0.0.675). For understand levels of roam-factor I used https://support.ruckuswireless.com/articles/000002277.I set strong ro...

I test Auto Cell Sizing between R510 and R720. They are both controlled by vSZ 5.0.0.0.675.On controller I see that R510 and R720 are neibghours. But in console each AP there isn't similar entries. Will Auto Cell Sizing work properly in this situatio...