Commscope

chell_7zwe · 01-14-2022

Hello. I have rspan setup, but noticed on my workstation running Wireshark I'm only receiving outbound traffic from the source device. Without luck I've tried rspan source monitor-both eth 2/1/20 as well as rspan source monitor-in eth 2/1/20 AND rs...

chell_7zwe · 07-19-2021

Hello All. I've enabled BUM on three eth ports that have production, domain workstations connected to them. I configured rate-limit-log 1 globally. Below is what I have configured per port broadcast limit 1 kbps log multicast limit 1 kbps log un...

chell_7zwe · 08-28-2020

7uyuuyuy

chell_7zwe · 04-19-2021

I know this post is a bit old, but I finally upgraded the switch stack and wanted to share the outcome. So the flash still looked as it did per the output in an earlier post. Instead of trying to reload to code 8080f, I reloaded the switch as is wi...

chell_7zwe · 08-28-2020

The end goal is 8090f which I plan on going to within the same downtime window. Do you still recommend 8080f as the interim step? I performed the steps you recommended after erasing primary flash, but can't reload until a date is set in the near fu...

chell_7zwe · 08-28-2020

My apologies on what was typed...web filter. Anyway, I got some output from the switch stack to share. My concern is switch #1 of the stack flash doesn't show close to what switch #2 does once the ......FI08080e_Manifest.txt all-images-pri is tf...

Commscope

User Statistics

User Activity

Not Receiving Inbound Traffic on RSPAN Destination

BUM Suppression Logging

Upgrade 08030r to 08080e BUT Active Switch Flash Free Space Zero

Re: Upgrade 08030r to 08080e BUT Active Switch Flash Free Space Zero

Re: Upgrade 08030r to 08080e BUT Active Switch Flash Free Space Zero

Re: Upgrade 08030r to 08080e BUT Active Switch Flash Free Space Zero