CommScope RUCKUS Community Forums

andrew_somervil · 07-14-2018

We are seeing intermittent reboots of APs with this message showing in ZD as the restart reason. What is the cause of this?

andrew_somervil · 02-17-2017

If I purchase additional AP licenses on an SZ100 with Watchdog Support in place, how am I charged for support, e.g. only charged when the hardware support is due for renewal, or charged when the hardware support is due for renewal with pro rata backd...

andrew_somervil · 12-16-2021

@mohammad_shamseddine yes after hard reset you can access on default credentials and load standalone firmware

andrew_somervil · 10-13-2018

No

andrew_somervil · 10-04-2018

Sounds like a fair assumption. Try removing one of your existing APs to check.

andrew_somervil · 07-19-2018

You use option3. The procedure is as follows::1. Go to Configuration --> Local Subnets page2. Create a new subnet with local and starting IP addresses for LAN3. Specify how many DHCP users are allowed to receive an IP4. Assign this newly created subn...

andrew_somervil · 07-14-2018

If bridge to WAN is set then the AP isn't operating as a router so you will have no DHCP server to issue IPs.

CommScope RUCKUS Community Forums

User Statistics

User Activity

What does "target fail detect" mean?

Watchdog support on additional AP licenses

Re: Want to change the firmware of h320 to standalone after it joins controller

Re: What does "target fail detect" mean?

Re: [960 License threshold exceeded][AP Capacity License] limit reached at [90%].

Re: Cannot connect to SSIDs of Ruckus R710

Re: Cannot connect to SSIDs of Ruckus R710