CommScope RUCKUS Community Forums

We had a stack set up with a 7650 and 5 7450s.  There's an issue with the primary and secondary flash on one of the 7450s and, in trying to fix it, I rebooted the stack.  Now, the last two switches have been dropped from the stack and I would like so...

Is there a way to clear the error counters on an R600 access point, either via the SmartZone controller or the AP CLI?  Thanks.

We have two SZ-100 controllers and 925 APs.  We normally get one or two APs disconnecting daily (not rebooting, just getting the disconnected message) but over the last week or two, the number of AP disconnects has jumped to 20-30 a day.Question 1: w...

We have a 7750 as our core router and remotes sites with either a 7750 or 7450 as their router.  The configurations were set up by an outside vendor and they only answer about half my questions.The core 7750 has routes something like:ip route 10.10.0...

We had an outside vendor redo the networks at one of our sites so we have nice new stacks in our IDFs instead of separate switches.  In BNA, how do I look at a stack and see the details of the switches that make it up?  Thanks.