CommScope RUCKUS Community Forums

rohan_vanden_dr · 04-16-2016

Hi.I have 4 R710s connected to a Netgear GS752TP PoE switch which I cannot get to use PoE+ (802.3at) mode.Looking at some of the previous posts and information, I SSHed into each R710 and found LLDP initially disabled, so I enabled via CLI. Now get l...

rohan_vanden_dr · 04-18-2016

I actually have a Linksys LGS116P unmanaged switch which is PoE+ 802.3at capable. I've tried one of the R710s on that and it behaves the same. But as an unmanaged switch, I don't think it has LLDP support anyway, so that probably doesn't really help.

rohan_vanden_dr · 04-18-2016

There's only about 10 other PoE devices connected at the moment - mostly low power. The switch has a nominal power budget of 384W, but is currently only showing 60W consumption, so I assume nothing is getting throttled by the switch itself. I previou...

rohan_vanden_dr · 04-18-2016

Hi again.For what it's worth, this is the switch PoE status page (at the time I took this, 3 of the R710's were connected to ports g2 - g4), with port g1 - g8 all theoretically able to deliver full PoE+ 802.3at power, and all connected APs are correc...

rohan_vanden_dr · 04-17-2016

Hi. Thanks for the replies.I'm using a ZoneDirector 1200 with latest (9.12.2.0 build 204) firmware.I have actually already tried Dave Watkins' suggestion too (and I only use the System Default AP group) as per posting here - http://www.mirazon.com/en...

CommScope RUCKUS Community Forums

User Statistics

User Activity

Getting R710s to use POE+ (802.3at) mode on Netgear GS752TP switch

Re: Getting R710s to use POE+ (802.3at) mode on Netgear GS752TP switch

Re: Getting R710s to use POE+ (802.3at) mode on Netgear GS752TP switch

Re: Getting R710s to use POE+ (802.3at) mode on Netgear GS752TP switch

Re: Getting R710s to use POE+ (802.3at) mode on Netgear GS752TP switch