Just noticed that ZD1100 has a KRACK refresh release posted.Thank you.However the recommended release page showsbut associated release notes showby all means call me a pedant but could someone (Michael B perhaps) confirm that the release notes are in...
Just back from half-term and a look at my ZD Dashboard Usage Summary shows a minor gui curiosity...For "# of Rogue Devices" shouldn't the 24hr period include the 1hr period?So am I seeing 1hr info and then the previous 23hr info or...(to confuse you)...
In response to info from another thread I'm trying to rationalise my numerous WLANs (from 12 down to circa 6).
24hrs ago merged 4 WLANs into 2 in doing so removed WLANs called YELLOW and BROWN.
However today while digging around on an AP noticed th...
In a old thread (that I only noticed recently) it was mentioned that each SSID uses 2.3% of bandwidth. Not seen that figure mentioned before.
I use a lot of SSIDs (12) to segregate, assign and control different groups of school laptops. If this is ...
I see this here in school as well.
Typical scenario 8 classrooms (4 up 4 down) with 2 APs and I'll see 40 laptops in those rooms connect to 1 AP and only a few (5 perhaps) connect to the other AP. Would have expected a little more balancing between ...
ZD1100 will support R300 from 9.7 firmware. You're running 9.6.Upgrading to 9.7 needs planning/thinking, read release notes, make config backup.Think about best time as it might take 60mins to get your network backup as all the APs will upgrade once ...
Create AP groupAssign AP to AP groupCreate WLAN groupAssign WLAN to WLAN groupyou now can choose which WLANs to broadcast on APs in different AP groups.Seems clumsy and complex for a small number of WLANS and APs but when there are many allows great ...
They have an inbuilt tag called a MAC - you could use that.Bit of work involved in this solution. Use the MAC addresses to allow/deny to WLANs. You could:Create a unique SSID and add the AP to it.Assign an ACL (acccess control list) to that SSID wit...
