CommScope RUCKUS Community Forums

swim268 · 04-27-2024

I am trying to update my firmware for a malfunctioning Lennar/Amazon ICX-7150-C12P. None of the default passwords mentioned in other posts work to access the router. I tried booting in "no password" mode several times, and the router still asks for...

swim268 · 05-03-2024

Sorry. I followed all the steps and can get to stop 7, but once the PoE’s are enabled, the switch keeps asking for a password. I cannot get to the prompt to type “enable.”

swim268 · 05-02-2024

Thanks. I tried but it didn’t work. It stopped on the TFTP error after the POE ports booted. I tried going to zoos mode, but when I exited back, the router was asking for a password again. I tried the default password and no luck.

swim268 · 05-01-2024

I have the exact same problem as dgwatters. I cannot get to the command prompt to type enable. The switch keeps asking for a username and password.

swim268 · 04-30-2024

Thanks for the advice. I tried all of the password combos and they did not work. I reset the router exactly as shown in the video, retried all of the password combinations, and the router did not accept the passwords. I noticed that the router is ...

CommScope RUCKUS Community Forums

User Statistics

User Activity

Keep getting request for "User Access Verification", even when typing "no password" when booting.

Re: Keep getting request for "User Access Verification", even when typing "no passwor

Re: Keep getting request for "User Access Verification", even when typing "no passwor

Re: Keep getting request for "User Access Verification", even when typing "no passwor

Re: Keep getting request for "User Access Verification", even when typing "no passwor