CommScope RUCKUS Community Forums

beanradio · 11-07-2023

I have a Lennar home with an ICX 7150 12P switch connected to two R510 access points. One of the APs is located on the third floor and the other on the second floor. The one on the second floor is connecting but the PWR light is blinking green. I’m a...

beanradio · 11-13-2023

Hello, a quick update. I had to order some extra large RJ45 connectors because the ones that came with the compressor tool were cat6 but weren’t big enough. The cable is a cat6a and has slightly bigger gauge. I was able to attach a larger connector a...

beanradio · 11-10-2023

Understood. I think the problem is with the cable on the second floor hookup. I checked the RJ45 connector and two of the wires were loose and came out. I ordered a RJ45 compressor tool with connectors to reattach a new connector and see if that reso...

beanradio · 11-09-2023

I’m not sure I understand what you mean by check to confirm common Lennar setups, I’ve already confirmed this in my reply.As far as doing a factor reset I’ve followed the instructions and tried this several times and have the same issues. It is just ...

beanradio · 11-08-2023

I confirmed the connection from my router to the 7150 switch is on one of the 12 ports in the middle section of the switch. I have a router/modem, it is a Verizon brand unit.1. Was this working before or is it a new installation? If it worked before,...

CommScope RUCKUS Community Forums

User Statistics

User Activity

R510 PWR light blinking green and won’t retrieve IP

Re: R510 PWR light blinking green and won’t retrieve IP

Re: R510 PWR light blinking green and won’t retrieve IP

Re: R510 PWR light blinking green and won’t retrieve IP

Re: R510 PWR light blinking green and won’t retrieve IP