CommScope RUCKUS Community Forums

marc_van_houwel · 03-10-2015

I am trying to setup a link with a Root Bridge to a Non Root bridge. Once I choose a channel I am getting a good link. The Up/Down is 10/9 and RSSI is 39/36. From my understanding this is a descent link. However when I run the SpeedFlex test I am loo...

marc_van_houwel · 03-18-2015

Does that require the full support contract? I am working on getting our contract updated. Also would a firmware upgrade possible help?

marc_van_houwel · 03-18-2015

Well what I don't under stand is three weeks ago we were getting about 20megs on this link. I then tried to change it to a 40mhz channel to increase the bandwidth. Once I did that the whole link went to crap. I am not an expert with these radios. Im ...

marc_van_houwel · 03-18-2015

Here are the errors I'm getting from the log file. I need to get this resolved as soon as possible because I need to start putting customers on this link. OUr distance is 27KM. and the throughput is between 1-3Meg

marc_van_houwel · 03-17-2015

I have a RB to NRB link and I have it on a channel that has good RSSI. However when I run a speedflex test the throughput is very low. Any steps to troubleshoot this

marc_van_houwel · 03-17-2015

So this would tell me the lower the number the better??

CommScope RUCKUS Community Forums

User Statistics

User Activity

7731 RB -NBR Problem

Re: 7731 RB -NBR Problem

Re: 7731 RB -NBR Problem

Re: 7731 RB -NBR Problem

Re: 7731 RB -NBR Problem

Re: 7731 RB -NBR Problem