When statically configuring bandwidth, will the lower bandwidths still be supported?For example if i configure 40MHz,
will 20MHz only clients still be allowed on the WLAN? 80MHz will no
longer be used in this case?Br.Koen
Does anyone have experience directing syslog messages to Kiwi Syslog server? No messages are coming into the server, i am listening on UDP port 514 and followed the following document on the Ruckus support site: https://support.ruckuswireless.com/ans...
Anyone got an idea what would force an Disassociation frame send by Android
device to Ruckus access point, reason code: "Disassociated because
sending STA is leaving (or has left) BSS (0x0008)? Then: deauthentication reason code: "class 2 frame re...
Hey all,Let me describe the issue. The client has 2 ZD3000 series located somewhere in Antwerp Belgium. The customer has several sites and access points are installed at these remote locations (around 270 access points in total). The access points ar...
If auto recovery is enabled, then clients that were already authenticated/associated to the access point will stay connected and keep their data connection, the AP will then reboot after the timer expires and the existing clients will loose their con...
Make sure that both ZD5000 have the same firmware version as well as the number of licenses or it won't work. So there will be interuptions (about 4 to 5 upgrades i think) while performing these upgrades. Otherwise you can configure the new ZD exacet...
Michael,
"Ruckus ZoneDirector maintains client session information between APs for smooth
roaming transitions."
Is this also true without 802.11r & 802.11k implemented?
Is buffered data forwarded between AP's via the zonedirector when tunnel mode...
