ZD1100 issue in rescue mode & status blinking red

Anonymous · ‎10-02-2020

Hi.

Recently I had to upgrade zd1100 from web gui but after restarting ZD, waiting for about 2 hours but nothing happened and I did hard reset but again it didn't come back and ping to default ip was unreachable.

From ruckus forum I realized that rescue mode is solution. Follow the steps I did fdisk and then upload firmware. But after it showed me "Upgrade Complete. System reboot" ZD status from off switched to red blinking. What can I do?

Image_ images_messages_5f91c3f2135b77e2478f544e_5a6f65584fa7020380a18c8fd7b0a996_RackMultipart20201002124401d60-cf6c2f36-8ccc-4c80-976a-8b467e65b9ff-783722136.JPG1601664829

Image_ images_messages_5f91c3f2135b77e2478f544e_5b94f0d3b00ed16d556d2f1e31ff306a_RackMultipart20201002109653ou7-81735022-32ca-47db-bbbe-98cf7cc33395-1641734524.JPG1601664867

santhosh_dk · ‎10-02-2020

Hi Ahmad

Please follow instructions from the link below to recover Zone Director. If it fails, please reach out to Support for replacement. Kindly note a hardware Warranty on the unit is necessary to process replacement.

https://support.ruckuswireless.com/articles/000001481

Regards

Santhosh

Anonymous · ‎10-02-2020

Thanks, but now I can't access to the premium account in order to open the link, As you see my steps to get back ZD, is anything more to do ? or do you have any advice?

Anonymous · ‎10-02-2020

Thanks, but now I can't access to the premium account in order to open the link, As you see my steps to get back ZD, Shall I do more than the activities I have than on ZD so far? Do you have any advice?

Anonymous · ‎10-02-2020

Thanks, but now I can't access to the premium account in order to open the link, As you see my steps to get back ZD, Shall I do more than the activities I have done on ZD so far? Do you have any advice?