02-02-2021 05:54 PM
Hi,
When i have a range of AP's on a zone director 1200 ,the zone director flashes the firmware, to match the ZD.
So Which set of SNMP files do i use for the setup, to query the individual AP's
do they fall under the Zone directors, SNMP MIB files for the relevant SW,
or do I still need a separate MIB files for each AP with a different model number. , and if so WHICH MIB files, since the separate MIB files are tagged with the firmware number in the down load section and for Zone directors flashed version, they are not available.
so i can query the serial number for the ZD1200 with:
.1.3.6.1.4.1.25053.1.2.1.1.1.1.15
what do i need to query each AP? (R500) ,since
.1.3.6.1.4.1.25053.1.2.1.1.1.1.15 = No Such Object available on this agent at this OID
is returned for the AP's
02-25-2021 02:07 PM
Hi,
I don't think you can query APs directly if they are managed by ZD.
All the OIDs will hit ZD and ZD will provide the available information.
There are no separate MIBs for ZD managed APs.
02-25-2021 07:21 PM
it seems not correct.
you can address both the ZD1200 AND the access point....
it looks like maybe the ZD SNMP settings "bleed" down to the access points.
Also there are strings in the MIBS that are inconsistent or defined more than once for different SNMP quires.
02-28-2021 08:56 AM
Hi,
There is no direct SNMP configurable option for APs. However, you can enable SNMP Inherit option on ZD SNMP settings.