Unleashed mgmt-acl & LACP

[taylor_sanders]

Hi,

First time trying Ruckus and got 3x R710s on Unleashed 200.9.10.4.233.

Looking for two things in cli but not finding.  Unsupported?

1) Mgmt-acl - https://docs.commscope.com/bundle/unleashed-200.9-commandref/page/GUID-4D9DBEAA-A3A9-43E3-BE31-3DA01...

On config-sys context I don’t have mgmt.-acl.  Only mgmt.-if

ruckus(config-sys)# mgmt-acl macl1
The command is either unrecognized or incomplete. 

How to set management ACL on unleased? 

2) I believe LACP may not be fully supported on R710 unleased but running into blocked KBs when searching.

https://forums.ruckuswireless.com/conversations/ruckus-indoor-aps/r710-lacp-and-200810/5f91c3f1135b7...

I did find LACP procedures here but not finding xmit-hash or lacp-rate? 

https://forums.ruckuswireless.com/conversations/ruckus-indoor-aps/lacp-on-r710/5f91c3f3135b77e2478f6...

ruckus(ap-mode)# get bond

LACP/Bonding is ENABLED.

<bond0>

        Mode:           8023AD

        LACP-rate:      slow

        MII-Mon:        100 (ms)

        Xmit-Hash:      layer2+3

        Slaves:         2

        Slave-0:        eth0, ACTIVE, UP, link-fail-count: 0

        Slave-1:        eth1, BACKUP, UP, link-fail-count: 0

OK

Thank you.

[syamantakomer]

Hi Taylor,

Mgmt ACL and LACP both are not supported on Unleashed at present.

LACP will be supported in upcoming 200.10 version so wait for it. Tentative release date is mid May.

[vesalius]

@syamantak_omer this is older, but now that 200.10 is here and we can enable lacp, but it seems the prior commands to change the xmit-hash no longer work.  How do we we change the LACP lag to layer3+4 xmit-hash in 200.10 these days and why was this option removed? I'm using an r710.

status-lacp enable

get bond
<bond0>	
Mode:		8023AD	
LACP-rate:	slow	
MII-Mon:	100 (ms)	
Xmit-Hash:	layer2+3	
Slaves:		2	
Slave-0:	eth0, ACTIVE, UP, link-fail-count: 0	
Slave-1:	eth1, ACTIVE, UP, link-fail-count: 0
OK

set bond bond0 xmit-hash 1 (no longer works to change to layer3+4 xmit-hash) 

[syamantakomer]

Hi Harold,

Please open a case with support with this issue and they should be able to check for any design changes or a issue.