cancel
Showing results for 
Search instead for 
Did you mean: 

Unleashed management vLan

nir_lazar
New Contributor II

Hallo All,

I'm managing 9 vlans environment. each vlan represents wLan and all works like a charm.

only issue is when i'm trying to access IT wLan on a management vLan (management vLan lists all network appliances e.i. AP’s, Firewall, switches Etc), i cant get a DHCP lease. and i know why. its because i gave the master AP an IP address (on the management segment vLan) on the default unleashed vLan.

on all switches i could change management vLan and on unleashed i cant find how to change the management vLan.

when i'm trying to change the management vLan i get a message i cant change the IP address for its the same subnet as defined on the master’s IP add.

please help.

Nir

 

 

1 ACCEPTED SOLUTION

syamantakomer
Community Admin
Community Admin

Hello All,

Management VLAN support was added to 200.13 version.

Please refer the 200.13 what's new guide


Syamantak Omer
Sr.Staff TSE | CWNA | CCNA | RCWA | RASZA | RICXI
RUCKUS Networks, CommScope!
Follow me on LinkedIn

View solution in original post

13 REPLIES 13

Squozen
Contributor III

You don’t need to set the VLAN on the AP - just set the native VLAN for the trunk on the switch end to the management VLAN. 

nir_lazar
New Contributor II

this is how i did it for all the AP’s (not just the master). 

nir_lazar
New Contributor II

Untagged on the management vLan and Tagged on all other vLans

Ok, then I’m not quite sure what you’re asking to do. Sounds like it’s not the VLAN you’re trying to change but an IP?