cancel
Showing results for 
Search instead for 
Did you mean: 

R500 Member not connecting to the master ?

petar_sasic
New Contributor

R500 has been unleashed and is the master , no members show up , ive located them in the ipscan and i can log into them but they do not show up on the dashboard  

4 REPLIES 4

Vineet_nejwala
Moderator
Moderator

Hi @petar_sasic 

1) All the AP's should be configured in same subnet for auto join, if member AP is running on different subnet, manually need to set the current master IP address IP, in member AP using below :
  set director ip xxx.xxx.xxx.xxx 
 Where x.x.x.x is the IP address of the current master AP.

2) Make sure to manage all the AP's in same firmware version (Member AP firmware should be =< Current master AP firmware). "get version"

3) The country code on all the AP's should be same "get country-code"

4)Login to member AP CLI (SSH), execute 'get discovery-agent' to check the status of 'Discovery Agent, to Enable  Execute command 'set discovery-agent enable'. The AP should start sending out discovery packets and join the ZD/Master AP.

https://support.ruckuswireless.com/articles/000005680

Best Regards

vineet

sunny_gupta
Contributor II

Check that the new member access points are running the same version of Unleashed code as your master otherwise they won't join.

petar_sasic
New Contributor

thank you very much, all access points are up and working 

@petar_sasic

Glad this is sorted.


Best Regards

Vineet