CommScope RUCKUS Community Forums

ian_inson · ‎11-14-2020

Hi, I have a R510 on unleashed, today I have been given an R500 that has been converted to unleashed also, problem is I can’t find a way to mesh them.

regards,

K

dan_kern · ‎11-14-2020

In all likelihood, you will need to DOWNGRADE your installation of Unleashed to accommodate the R500 Access Point.

The last supported version of Unleashed was Ruckus Unleashed AP 200.7.10.202.121 (MR Refresh5) Software for R500.

Evidently, the firmware beyond this release is too large to fit on the R500 Access Points, so they are no longer supported in firmware versions newer than this one.

Since the R500 Access Points are no longer supported, no additional firmware will be created for them unless some glaring security problem surfaces in the future. If you are ok with that, then using this firmware on both the R500 and R510 AP's should allow you to run them under Unleashed and Mesh them.

Here is the link to the firmware if you need it.

https://support.ruckuswireless.com/software/2649-ruckus-unleashed-ap-200-7-10-202-121-mr-refresh5-so...

Here is a link to the Release Notes which I suggest you review before deciding which way to proceed.

https://support.ruckuswireless.com/documents/3467

Personally, I have 4 of the R500's setup in my home. Two of them are hardwired to my main router, and the other two are Meshed off of the first two. They have worked flawlessly since installing them.

Hope this helps!

View solution in original post

CommScope RUCKUS Community Forums

How to upgrade R500