RUCKUS Forums - To Be Moved - Page 39 - CommScope RUCKUS Community Forums

Ruckus Wireless

|

To Be Moved

Forum Posts

Sorted by:

ASK the Pack

Repeated daemon.err channel messsage on P300 log, fluctuating connection

After experiencing intermittent performance issue (ping loss, total disconnect) with our P300-P300 bridge setup we looked into logs and found following happening in regular interval. The APs are 1.6KM apart and no aparent LoS issue.The performance dr...

external ip

Hi all I need to change the external IP address of the VSG i know that ther is ascript i should run on the ap's i need this script can someone send me ?

Use Ruckus AP as 802.1x supplicant

we are starting with 802.1x wired authentication and i wanted to ask, if it is possible to use the AP as a supplicant. so the AP authenticates itself on the switch with 802.1x so the switchport is only open, when the AP is connected. The wireless dev...

Zoneflex 7321 setting

Hi, I have a Zoneflex 7321 which is supposed to act as a signal extender for my master bedroom - I have tick brick walls and the main signal does not get there. It is wired into my hub downstairs and it was installed by my smart home integrator 3 ye...

In a TurboIron 24x is a static trunk load balanced the same way as an active link-aggregation?

I have two Brocade TurboIron Ti24x running 8.00.1b. Between the switches I have ports 18 and 19 configured as a trunk. If you show the config you can't see it, but I'm pretty sure a few years ago it was configured using this command:(config)#interf...

Related Self-Help

Find More Solutions