CommScope RUCKUS Community Forums

kjstech · 01-17-2018

I have two Brocade TurboIron Ti24x running 8.00.1b. Between the switches I have ports 18 and 19 configured as a trunk. If you show the config you can't see it, but I'm pretty sure a few years ago it was configured using this command:(config)#interf...

kjstech · 01-18-2018

Ok the Tegile controller A is LACP passive to TurboIron switch 1, ports 21 and 22, setup as link aggregation (in active mode).The Tegile controller B is LACP passive to TurboIron switch 2, ports 21 and 22 as link aggregation (active).So between the s...

kjstech · 01-17-2018

So on the static trunk between the switches, i’ll never max it out at 20gbps unless I tear it down and reconfigure it as a link-aggregate? I do see bandwidth on both ports, however when I fail that storage controller to B, most I get is like 1.4GBps...

CommScope RUCKUS Community Forums

User Statistics

User Activity

In a TurboIron 24x is a static trunk load balanced the same way as an active link-aggregation?

Re: In a TurboIron 24x is a static trunk load balanced the same way as an active link-aggregation?

Re: In a TurboIron 24x is a static trunk load balanced the same way as an active link-aggregation?