I push the reset buttom for more than 15 seconds, and now i can't get teh dir IP 192.168.0.1 to set up the wireless..

[henry_tibanlomb]

can't reset the R300 AP

[sanjay_kumar]

Hi Carlos,

The password will be "ruckus-admin password". Since it is standalone AP and assuming that it has not taken the config from the controller, the password would be "ruckus-sp-admin".

Try this and let me know.

Below are some more information about the Island SSID.

https://support.ruckuswireless.com/articles/000001524
https://support.ruckuswireless.com/articles/000004181

[carlos_nitsch_g]

excuse me if I didn't understand
What i tried to explain was that the ssid island, when i choose It to Connect neither the Mac address or the serial number are allowing to Connect the wifi Network. So i already did Factory reboot and by poe injector with 192.168.0.1 make ping and does not respond. Do u think that firmware IS corrupted.? I Aldo tried Shell and telnet and nothin ping is not responding. That IP address that you salud IS diacovered by IP scan but i can not reach by the same reason that i can not Connect to islandxxxxxx ssid.
I Hope we can solve this issue
Thanks a los