vSZ-H, how to set the transmission speed for 2,4?

[alexander_moise]

Hi everyone!
We build a wireless network for entertainment park. They use wireless Intercard debit card readers.

setting the wireless network manual for these reader says that 
**Be sure to also set the Transmission Speed of 2,4 GHz  Radio interface to 2Mbps**

How can this be done via vSZ-H ? Or could it be done at all? 

Thank you all in advance.

[michael_brado]

Hi Alexander, I kinda think the Intercard debit reader author needs to be clearer.
Transmission (tx_power) is measured in dB, not measured in Mbps, as are Data Rates.
I'm pretty sure they want to make sure we respond to probe requests and beacons seen at 2mbps data rates
in case/if they might be only 802.11b wifi capable.

Pls see this table under Protocol on the Wikipedia page for 802.11:  https://en.wikipedia.org/wiki/IEEE_802.11

But further to your question, we can only configure the Minimum rate, from 2 -> 5.5 -> 11, but not down/only
to a Maximum of 2mbps.