r310 and VSZ AP detection

[xxfisherxx]

I followed all of the steps for the first AP  in the education video and cant see my AP in the staging area inside of virtual smartzone like in video,  is there a setting inside of VSZ that I'm missing. also is there an easier way to deploy, detect and configure as I have 50+ to do and this seems not very efficient

[James]

Hello,

I understand your R310 AP is detected by the vSZ controller. Please check/ provide the following details.

> Are you using a vSZ-Essential (vSZ-E) or vSZ-High Scale (vSZ-H) ?

>What is the current firmware on the AP, and that on the SmartZone?

>If you are using vSZ-E, what is the firmware on the default AP zone ?

>Please confirm if you have sufficient AP capacity licenses available on the vSZ.

DHCP option 43 sub opt 06 can be used to provide the controller's IP to the AP.

The controller's ip address should be configured under DHCP opt 43 sub opt 06 in hex form. Please use the below link to covert decimal IP address to hex form.

http://shimi.net/services/opt43/index.php