Want to change the firmware of h320 to standalone after it joins controller

[mohammad_shamse]

Dears, 

I have some ruckus H320 that are joined to ruckus virtual smartzone essential, their firmware version is now 3.5.1. For some requirement, i want to disconnect those aps from the controller, and convert their firmware to standalone, but now when i attempt to access the ap via web to change its firmware, it is failing probably because it is running now the controller based firmware. Would you please advise on how at this phase i can change the firmware of the AP ?

Thanks and Best Regards

[Vineet_nejwala]

Hi @mohammad_shamseddine 

If you are unable to access this AP on WEB, login to AP CLI and execute below :

set https enable

Once above is completed, execute below :

set scg init

set scg reset 

Login back to AP WEB and you should see the upgrade tab, if not try above two commands couple of time, finally if it is not giving upgrade tab, you would have to perform a factory default on this AP using below command :

set factory

Best Regards

Vineet

[mohammad_shamse]

Hello,

Thanks for your reply,

What would happen if i performed a hard reset for the AP ? When it boots again will i be able to access it via web ?

Regards 

[Vineet_nejwala]

@mohammad_shamseddine

Yes, post hard reset you would be able to access via WEB on its IP.

Best Regards

Vineet

[andrew_somervil]

@mohammad_shamseddine yes after hard reset you can access on default credentials and load standalone firmware