How to set static IPs instead of DHCP on APs using script on SmartZone

[bart_p_izj2rmjl]

Hi, I have SmartZone with 490 APs, I need to set static IP addresses, at the moment APs are operating via IP from DHCP. Is there any possibility to configure each AP via SZ's cli, like I did in ZD's case?

I need a script example, please advise

[bart_p_izj2rmjl]

5.2.1.0.515 fw

[syamantakomer]

Hi Bart,

You can use vSZ remote AP CLI command to update the AP IP (similar to ZD remote AP CLI).

Here is the example.

login as: admin
################################
#       Welcome to vSZ         #
################################
admin@xx.xx.xx.xx's password:
Please wait. CLI initializing...
 
Welcome to the Ruckus Virtual SmartZone - Essentials Command Line Interface
Version: 5.2.1.0.xxx
 
vSZ> en
Password: ***************
 
vSZ#
vSZ#
vSZ# remote ap-cli
       AP MAC address
 
vSZ# remote ap-cli 2c:c5:d3:09:ab:c0 "set ipaddr wan xxx.xxx.xxx.xxx yyy.yyy.yyy.yyy zzz.zzz.zzz.zzz"

In the above, x=AP IP, y=subnet, z gateway.


Regards,
Syamantak Omer

[bart_p_izj2rmjl]

Hi Syamantak,

Many thanks for your answer! 

Do you know how to change internal IP instead of external?

[bart_p_izj2rmjl]

Is it related to this:

set ipmode : set ipmode {wan|lan|video|mgmt} {ipv4|ipv6|dual}
                ipv6-only cannot be set when hotspot or router mode is enabled -- Modify IP Mode
set ipaddr : set ipaddr {wan|video|mgmt} [vlan ] {options}
                 -> "static IP case"
                 -> dynamic                      "DHCP case     "
                 -- Modify IP address
set dvlan  : set dvlan {enable|disable}
                 -- Modify AP WLAN's dynamic VLAN mode