Enable 802.11h in vSZ-H

[ali_db0udsohr2q]

I can't seem to find where to enable 802.11h in the vSZ-H.  Documentation shows that ChannelFly uses 802.11h.  I enabled ChannelFly but still don't see 802.11h in the captures.  What am I missing here?

[syamantakomer]

Hi Ali,

For more information on 802.11h, please refer below articles.

https://support.ruckuswireless.com/articles/000003344

https://support.ruckuswireless.com/articles/000001934 

Regards,
Syamantak Omer

[ali_db0udsohr2q]

Thank you, good info.  So basically the only way to enable it via CLI then?

[ali_db0udsohr2q]

Also I did check with "get 802.11-h wlan32" 802.11h is enabled but I don't see it nor I see any TPC Report IE.

[Anusha_Vemula]

Ali,

Yes, for now you can enable/disable 802.11h from the CLI only.

Please open a support ticket and attach the captures to verify this further.

- Anusha