cancel
Showing results for 
Search instead for 
Did you mean: 

Dynamic VLAN in Non-Proxy (AP Authenticator) mode

pawelm
New Contributor

Is it possible to assign a client to VLAN through a VLAN attribute (i.e. Dynamic VLAN) with non-proxy mode (AP Authenticator) mode?

I have found Authentication Support Matrix ( https://docs.commscope.com/bundle/sz-600-adminguide-sz300vsz/page/GUID-A4BFE365-B8B5-4518-A24B-A3968...) but the relevant table is empty (missing data?)

Kind regards,

Pawel

1 REPLY 1

DarrelRhodes
Contributor III

Hi Pawel,

I'm sure it is possible to configure dynamic VLAN with non-proxy mode, as non-proxy is the default setting for .1X networks. This documentation directly references "the AP", so I'm sure you're good! https://docs.commscope.com/bundle/sz-510-adminguide-sz300vsz/page/GUID-46F41909-A422-4DEA-ACE2-F6216...

Thank you for bringing the documentation issue to my attention, I have reported this to our docs team to investigate and rectify. Although I suspect this isn't a quick fix!

I hope that helps,
Darrel.