This website uses cookies. By clicking Accept, you consent to the use of cookies. Click Here to learn more about how we use cookies.
Accept
Reject
RUCKUS Self Help |   ASK the Pack
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

Change the cluster Control IP

Go to solution
yossia
New Contributor

‎12-25-2023 04:08 AM

Hello all,

i have in my environment 2 nodes of Virtual SmartZone. today the remote sites connecting via Layer 2 Point to Point Lines and the access points are in the same subnet with the cluster Control IP. i am going to change the network topology and the remote sites will connect via Layer 3 IPSEC Tunnels so i have to change access point ip addresse.
in addition, i want to change the Control IP address, what are the consequences? it is matter to which interface the access point is reaching?

Best Regards,
Yossi.

0 Kudos
1 ACCEPTED SOLUTION

Go to solution
Parik_MN
RUCKUS Team Member
In response to yossia

‎12-25-2023 04:47 AM - edited ‎12-25-2023 04:48 AM

Ok that sounds like a minor changes @yossia. You could update the controller IP in DNS. Upon AP reboot they would get a new IP address. Then the Control IP can be changed.

Note that, IP address change would take about 10 minutes to take effect on the interface.

Regards,

Parik

View solution in original post

0 Kudos
4 REPLIES 4
Copyright © 2024 Khoros, LLC